coffee forum, ?????, ?????, fresh coffee beans and tea house 首頁 coffee forum, ?????, ?????, fresh coffee beans and tea house
??????, ??, ??????
 
 常見問題常見問題   搜尋搜尋   會員列表會員列表   會員群組會員群組   會員註冊會員註冊 
 個人資料個人資料   登入檢查您的私人訊息登入檢查您的私人訊息   登入登入 

Cona Siphon Brewer

 
發表新主題   回覆主題    coffee forum, ?????, ?????, fresh coffee beans and tea house 首頁 -> ???/????????
上一篇主題 :: 下一篇主題  
發表人 內容
Peter



註冊時間: 2011-02-18
文章: 243

發表發表於: 星期一 八月 08, 2011 1:55 am    文章主題: Cona Siphon Brewer 引言回覆

Despite its age (this model was produced since 1960s http://www.cona.co.uk/about.php), I think it looks quite stylish and is well made. It's using a glass rod filter and is good that I don't need to worry about washing the cloth filter. I thought without using any cloth filter, there would be quite some sediments at the bottom of the coffee. However, to my surprise, there's really not much sediments at all.

The flat base of the bottom flask can also allow direct sitting on any town gas stove. Brewing temperature can easily be controlled at between 75'C and 93'C (but the bubbles coming up the tube would be too large) depending on flame power. I had also read some articles about the strength of the glass used by Cona and I could spray water onto the lower flask (do it at your own risk!!!) to cool it without worrying about cracking it. In 2-3 seconds time, the coffee is sucked back to the bottom flask quite vigorously due to the rapid cooling and brew time thus can be accurately controlled.

The worst thing is that there's half the flask of water retained in the bottom flask (due to the "short" tube of the upper flask) but I'll try to see if I can cut out part of the rubber to let the tube sit deeper.

回頂端
檢視會員個人資料 發送私人訊息
從之前的文章開始顯示:   
發表新主題   回覆主題    coffee forum, ?????, ?????, fresh coffee beans and tea house 首頁 -> ???/???????? 所有的時間均為 台灣時間 (GMT + 8 小時)
1頁(共1頁)

 
前往:  
無法 在這個版面發表文章
無法 在這個版面回覆文章
無法 在這個版面編輯文章
無法 在這個版面刪除文章
無法 在這個版面進行投票


Powered by phpBB © 2001, 2005 phpBB Group
正體中文語系由 phpbb-tw 維護製作